A Tale of Tails

​I've made two furry heads! Yay! Next, making tails and paws to go with them! Whee!! This blog post will cover my tail making adventures, the next will cover my forays into paws.

First, a pattern! Pressing my poor kid into service as a model,  and sketching a pattern for a wolf tail. (My kid is begging the cat to come rescue her.) 

Next, hitting the Interwebs for all the tailmaking tutorials I could find.  Kloofsuits' was one of my favorites (view here). Switch Cosplay's was another (view here). The biggest difference I found between these two was the their methods for making the belt loops, Kloofsuits' below left and Switch Cosplay's below right. (That's my very helpful hubby holding the tails up and mugging it up for the camera.) I ultimately decided on Switch Cosplay's method, as the loops were less visible when the tail was worn by itself on a belt. Kloofsuits' method is less fiddly and probably stronger, but I suspect it's meant for tails to be worn through a hole in a fullsuit, where the loops would not be visible anyway. 

 Wait a minute, math?? These equations are for figuring out the diameter of the tail "cap" in Switch Copslay's method if I had the measurements of the end of the tail, and vice versa. These saved me endless amounts of trial and error and frustration. (Thanks to my ever amazing hubby for coming up with these for me!)

I also did a lot of experimenting with the same pattern using different numbers of pieces, placements of seams, and direction of fur, the sketch above showing the different variations I tried. The one on the far left represents a tail made of two halves sewn together front and back. The advantage is obvious- super simple to make. The second one from the left is made of four pieces and has a seam going down either side as well. This helps give the tail a fuller, rounder look. The third pattern is made of eight pieces and is good for a tail with a black or white tip, and would also allow the fur to follow the tip's curve more closely. The last one is made of twelve pieces and can be used for a tail with a different colored underside, and allows the fur at the top to follow that curve more closely. I made all of these tails out of my solid, "cheap" white fur to be able to see any difference most clearly, and while I did like the way the fourth variation came out the best, I'm not sure I liked it that much better to justify the extra time it took. We will see. One thing I DID like about the fourth variation is that I could cut it out of my fabric with much less waste, since it was easier to fit the smaller pattern pieces on odds and ends I had on hand.

Here I am, experimenting on kids again. (They are expressing their sentiments on the matter, though that is harder to do with four fingered handpaws). Both these tails are made from the same pattern,  but the one on my long haired daughter is the two piece variation, and the other on her BFF is the four piece one, with a seam running down the sides as well as the front and back. The thing that struck me most about these tails however was the way they seemed to come out of the kids' back at right angles, which made them look more like horse tails than wolf tails. Back to the drawing board.

Above, tail pattern, take two.  While I like this one better I still think it comes out of the back at too sharp of an angle. As I often do, I printed out the photo and sketched ideas for changes on it, and used that for a reference for the third pattern.

 Above, showing tails I made from the three patterns I did side by side, the one on the right being one being the one I ultimately wound up using. You can see the different angles at which they come out of the  back. The one on the left is the four piece variation, the other two are the most complicated twelve piece one.

And TA DA!!! A finished tail, made out of "good" fur, intended to be part of a partial! This is the variation made with twelve pieces, with my third pattern above. Can't wait to start the head. Whee!!!!