Lips!

​Looking over my photos on my Facebook page I realized I had wanted to do a post about making lips for my masks but forgot! So here goes!

The snaky looking thing in the long moldbox on the right hand side of this pic is my first attempt at a lip for my resin wolf head. I sculpted it pretty straight because that's how I had seen other lips sculpted  online. Silly me.

Above, trying to fit a silicone cast of this straight lip on my mask. You can see how it gaps underneath, between the lower edge of the lip and the jaw. No good.

Above, trying to glue the new lip on. I think that pile of clamps might be trying to tell me something.... 

Making a pattern for a more fitted lip. The green thing above is Frog Tape stuck to aluminum foil. I pressed a piece around the lower jaw, sketched the shape of the lip on it, and cut it out. I then made it symmetrical by folding it in half in the middle and trimming it so the two sides would match. Then I tried out the new shape back on the head (above), trimming and fiddling until I was happy with it.

Here I've built the lip up in Monster Clay. It's built right on top of the pattern thingy, stuck on around the edges with a little more Monster Clay, so I can fairly easily remove and reapply the lip to the mask or adjustments as needed. 

Above, the two clay lips next to each other for comparison. The new lip is on the bottom. Very different shapes. 

Gluing silicone casts of the new lip in place. Not so many clamps needed this time! (The rubber bands here are actually serving as clamps here too.) I tried using Weldbond instead of hot glue, as Weldbond is theoretically stronger and doesn't leave those lumpy ridges when it dries. Weldbond takes about 24 hours to fully cure, hence the clamps. It did a good job, but I'm not sure it does enough of a better job to justify the long wait time. 

And, the new lips freshly installed. Wheee!!